Kathrein DVB Cable Receiver UFC 662sw - Manual (Page 51)

51
SETTINGS
Inserting the CA module into the CI
The Common Interface (CI)

of the UFC 662sw is suitable for insertion of a CA (Conditional Access)
module and is located at the rear of the receiver. The CA module

draws in the Smartcard

(chip contacts pointing downwards and towards socket strip) which it then inserts into the CI slot

.
The Smartcard should be inserted into the CA module without exerting excessive force.
This also applies to inserting the CA module into the CI slot!
Do not use a lot of force and follow the instructions supplied with the Smartcard and the CA module.
To remove the CA module, pull the CA module back out of the Common Interface.

The screenshots below depend on the specifi c module and card, and so are only intended as
examples:
Press the

button to access the menu generated by the CA module:
From this menu, your card and your PIN code allow you to access various channels from your Pay-TV
provider.
“CryptoWorks” has been selected as an example here. The details can be different for each CA module.
Always follow the instructions supplied by your pay TV provider!
Note: The module displays may be shown in English, even if you have selected German as the
menu language, because the menu is generated directly by the module!