Knoll HDP460 - Manual (Page 7)

7
Setting up the Projector
There are a number of factors to consider when determining where to set up the projector,
including the size and shape of your screen, the location of your power outlets, and the distance
between the projector and the rest of your equipment. But here are some general guidelines.
NOTE: To ensure adequate cable access, do not place the
projector within 6 inches (0.15 m) of a wall or other object.
Position the projector on a flat surface (either on a table or ceiling mounted) at a right angle to the
screen.
The projector should be within 10 feet (3 m) of your power source and within 6 feet (1.8 m) of
your video source(s), unless good quality extension cables or baluns are to be used.
When installing the projector on the ceiling, refer to the installation guide that comes with the
Ceiling Mount Kit for more information. Knoll recommends use of the mount shipped with the
projector or the deluxe swivel Knoll CM26 ceiling mount. The addition of a CM20+6 extension bar
lowers the projector 6” per bar as required. The CM25EX is an adjustable extender that can lower
the projector 6.75” to 11” (17-28 cm). The ceiling mount kit may be sold separately.
Position the projector the desired distance from the screen.
The distance from the lens of the projector to the screen, the zoom setting, and the video format
determine the size of the projected image.
Projector Positioning
The projected image becomes larger as the distance between the unit and screen increases.
The manual zoom allows the distance from the screen to be within a minimum and maximum
range. See the chart on the next page for details. The example below defines the screen height,
width, diagonal, offset, etc. Note the bottom of the image starts about below the lens center with a
horizontally or flat mounted projector.