Kamera Werk Dresden PRO 150 User Manual
Page 7
KAMERA WERK DRESDEN GmbH
Page 7 of 15
Removing the film (NOBLEX PRO 150)
1. Turn the camera off at the ON/OFF switch (10).
2. Advance the winding disk (5) until the counter (5a) reaches position »S« and the start button (5b)
moves out of the camera housing. Turn the film advance knob at least 4 times to avoid
unintentional incidence of light.
3. Unlock the camera back (9) and open it.
4. Press the film spool down until it can be swung out and removed.
Please note
Do not change the film under a strong light source.
Inserting the film (NOBLEX PRO 175)
1. Turn the camera off at the ON/OFF switch (10).
2. Advance the winding disk (5) until the counter (5a)
reaches position »S«. (If necessary, press the shutter
release button (4) to advance to the position »S«.)
3. Unlock the camera back (9) and open it.
4. Insert the film spool into the left-hand compartment
(14) in the camera back.
5. Push the tongue of the paper lead under the pressure
roll (15).
6. Push the tongue of the paper lead under the fight
diversion roller (17) - it is located in the fight-hand
compartment behind the take-up spool (18) - and pull
it until the double arrow on the protective paper of the
film reaches the pressure roller (15).
7. Insert the take-up spool into the right-hand
compartment (18).
8. Thread the tongue of the paper lead into the empty
spool.
9. Turn the winding disk (5) until the double arrow on the
protective paper of the film is opposite the red dot on
the camera film guide (16). Make sure that the film is
wound snug onto the take up spool.
10. Close the camera back and at the
same time press the left diversion
roller (19) slightly to the back.
11. Lock the camera back (9).
12. Press the start button (5b). The
counter
is
released
with
that.
Remark: At older models the start
key (5b) isn't available yet. In this
case the shutter release button (4)
has to be pushed.
13. Advance the winding disk (5) in the
direction of the arrow until it stops.
The film counter should be at the
number 1. To take a picture turn the
camera on at the ON/OFF switch (10)
and press the shutter release button
(4).
Removing the film (NOBLEX PRO 175)
1. Turn the camera off at the ON/OFF switch (10).
2. Advance the winding disk (5) until the counter (5a) reaches position »S« and the start button (5b)
moves out of the camera housing. Turn the film advance knob at least 4 times to avoid
unintentional incidence of light.
3. Unlock the camera back (9) and open it.
4. Press the film spool down until it can be swung out and removed.