Kamera Werk Dresden PRO 150 - Manual (Page 9)

KAMERA WERK DRESDEN GmbH


Page 9 of 15
Filters and Close-up Lenses
As accessories for NOBLEX cameras we offer a wide range of filters and close-up lenses. NOBLEX
filters an close-up lenses are specially designed with a magnetic ring on the back surface of the
filter/close-up lenses. They can thus directly be fixed to the lens. For inserting the filter or a close-up
lens follow these instructions:
1. Turn the camera off at the ON/OFF switch
(10).
2. Push the double exposure button (6) to
position »M«.
3. Press the shutter release button (4) and hold
it pressed.
4. Turn the lens drum anticlockwise until it
reaches a stop.
5. Release the shutter release button (4).
6. Put the camera on its back.
7. Pick up the filter or the close-up lens by the
hole of the filter ring using a pair of tweezers
and insert it through the shutter slit. Place the
filter onto the lens. The filter is magnetically
held onto the front of the lens.
8. Turn the lens drum back until it is engaged.
9. Push the double exposure button (6) back to
single exposure, if desired.
When removing the filter or the close-up lens follow the same procedure.
Please note
To step 5: If you turn the drum clockwise the film is exposed and you lose one picture. Please be very
careful when changing filters/close-up lenses in order to avoid damage to the lens caused
by the tweezers.
The Slow Exposure Module
The module for slow exposures offers you the opportunity to work comfortably with these NOBLEX
PRO cameras designed for the slow exposure module in the slow speed range. The necessary power
is supplied by the batteries of the camera.
Attaching to NOBLEX PRO
To attach the module to your camera please follow these instructions:
1. Remove the protective cap by turning the fastening knob (701)
clockwise.
2. Turn the camera off at the ON/OFF switch (10).
3. Turn the control ring (702) of the module until both white dots face
each other.
4. Attach the slow exposure module to the left-hand camera bottom so
that the guide pins (703) mesh with the inter-face (11) in the camera
bottom. At the same time the white dots of camera and slow speed
module must face each other.
5. Turn the fastening knob (701) until the module is tightly connected
with the NOBLEX camera.
To remove the module tram your camera please follow these instructions:
1. Turn the camera off at the ON/OFF switch (10).
2. Turn the control ring (702) of the module until both white dots face each other.
704
703
702
701