Kenwood HM-DV7 - Manual (Page 23)

23
Basic use method
Basic section
Muting the sound temporarily
÷ Press again to resume the original volume.
÷ This is also cancelled when the volume is changed.
Bass and treble compensation
(NB : Natural Bass circuit)
Each press switch the modes as follows.
1 "NB 1" (Only the lowest frequencies
are enhanced.)
2 "NB 2" (The lowest and highest
frequencies are enhanced according
to the current volume level.)
3 "NB OFF" (The source signal is pro-
cessed by the tone control circuitry be-
fore being output from the main unit.)
Tone adjustment
÷ The "BASS" and "TREBLE" can be adjusted inde-
pendently in the range from "- 8" to "+ 8".
1
Press the TONE key to select "BASS".
Adjust the level of lowest frequencies as de-
sired using the VOLUME keys.
2
Press the TONE key again while "BASS" is
displayed to select "TREBLE".
Adjust the level of the highest frequencies
using the VOLUME keys.
3
Press the TONE key.
MUTE
SOUND
The responses of the lowest frequencies (BASS)
and highest frequencies (TREBLE) can be ad-
justed as desired.After this adjustment, the N.B.
effect will be disabled.
TONE
∞ 5
VOLUME
\
Balance adjustment
The balance of volumes from the left and right
speakers can be adjusted as follows.
1
Press the MODE key.
2
Turn the VOLUME/MULTI CONTROL knob
to select "BALANCE", then press the SET/
DEMO key.
3
Adjust the left and right speaker balance by
turning the VOLUME/MULTI CONTROL
knob.
4
Press the SET/DEMO key.
- - - - L - R
URROUND
P.S.A.
NB
MHz
kHz
1 2
E B T L E R + 4
MUTE
Remote control unit only
Remote control unit only
Blinks
POINT SOURCE AUDIO function
Comfortable stereo sound can be enjoyed
regardless of where you are in the room.
POINT
SOURCE AUDIO
SURROUND
P.S.A.
MHz
kHz
1 2
Each press switch the modes as follows.
1 On : "P.S.A." lit
2 Off : "P.S.A." not lit
Adjust the subwoofer level
1
Press the MODE key.
2
Turn the VOLUME/MULTI CONTROL knob
to select "SW LEVEL", then press the SET/
DEMO key.
3
Trun the VOLUME/MULTI CONTROL knob
to adjust the subwoofer level.
4
Press the SET/DEMO key.
÷ Adjustment is possible over the range from "- 6"
to "+ 6".