Kenwood HM-DV7 - Manual (Page 8)

8
System connection
Preparation section
R
L
AUDIO
AUX
IN
CD - R
OUT S-VIDEO VIDEO
VIDEO OUT
CD - R
IN
− + − + − + −
+
1 2 3 4
GND FM75W AM
SUB
WOOFER
( 8 - 16 W )
TO OPM-DV7
SATELLITE
SPEAKER
+
-
ANTENNA
PCM/BIT
STREAM
OPTICAL
DIGITAL OUT
SUB
WOOFER
( 8 - 16
Ω )
+
-
1 2 3 4
TO OPM-DV7
SATELLITE
SPEAKER
Speaker rear panel
Satellite speaker
Speaker cord (accessories)
twist
÷ Never short-circuit the "+" and "-" speaker cords.
The protection circuit will operate and no sound will be put out.
÷ The "+" and "-" polarity are inverted, the sound will be unnatural with unclear localization of musical instruments.
Subwoofer
twist
Main unit
To wall AC outlet
1. Be sure to insert all connection cords securely. If their connections are imperfect, the sound may not be
produced or noise may interfere.
2. Before plugging or unplugging a connection cord, be sure to unplug the power cord from the wall AC outlet.
If connection cords are plugged or unplugged with the power cord left plugged in, malfunction or damage may
result.
Do not carry the subwoofer by inserting your hand in the hole on the front. Also take care not to touch the speaker
unit on the bottom when handling the subwoofer.
Be sure to adhere to the following, or proper ventilation will be blocked causing damage or fire hazard.
÷ Leave some space around the unit (from the largest outside dimension including projection) equal to or greater than,
shown below.
Back panel : 10 cm
CAUTION