Kenwood TM-455E - Manual (Page 82)

9 MCP-2A Memory Control Program (for use with TM-V71A/E, TM-D710A/E, RC-D710)
72 CONTENTS TM-D710A/E
9.3 Importing Other MCP Files into MCP-2A
With MCP-2A, it is possible to read a file that
was created using other MCP series software.
To read a file created by other MCP software,
select “Open” from the File pulldown menu.
In the Open window, select the correct file
type in the “Files of type” dropdown list, and
open the desired file.
Figure 9-7 MCP-2A Open Window
The files that were created by other MCP programs (except J-type) in the table below can be
imported into MCP-2A. The referenced software can be downloaded from the following web site:
http://www.kenwood.com/i/products/info/amateur/software_download.html .
Table 9-2 MCP-2A Importable File Formats Table
Only files created for K-type (U.S.A. and Canada) models can be imported into MCP-2A. The
referenced software can be downloaded from the following web site:
http://www.kenwoodusa.com/
Support/AMA_Radios/ .
Software Name
and Extension
Transceiver Model Remarks
MCP-2000 (*.2k0)
TS-2000
TS-2000X
TS-B2000 Unable to read memory channels that cannot be received by using
TM-V71A/E and TM-D710A/E.
TS-B2000 is only for overseas models (outside Japan).
MCP-D7G (*.d7g)
TH-D7A(G)
TH-D7A(G2.0)
TH-D7E(G2.0) Only for overseas models (outside Japan).
TH-D7 J-type (Japan) is unable to use due to command
specification differences.
MCP-2A (*.mcp)
TH-K2AT/ TH-K2E/
TH-K2ET/ TH-K4AT/
TH-K4E/ TM-271A/
TM-271E
MCP-F6/F7 (*.fx)
TH-F6A/ TH-F7A/
TH-F7E Memory channels that are outside of the receive frequency range
of TM-D710A/E or TM-V71A/E cannot be read.
MCP-D700 (*.700)
TM-D700A/
TM-D700E
MCP-D7 (*.d7) TH-D7A/ TH-D7E