Kenwood KRF-V7090D - Manual (Page 21)

21 EN
ENGLISH
Normal playback
Adjusting the sound
TONE
VOLUME
CONTROL ACTIVE EQ MUTE PHONES
LOUDNESS BASS BOOST
MULTI CONTROL
LOUDNESS
BASS BOOST
ACTIVE EQ
TONE
MUTE
VOLUME %/fi
MULTI %/ fi
Adjusting the TONE
You can adjust the sound quality when the receiver is in the PCM stereo
and analog stereo mode.
1 Press the TONE key to select the TONE mode.
2 Use the MULTI CONTROL knob or MULTI %/fi keys to select
TONE ON/OFF.
L
SL S SB SR
C R
SP MUTE
A B CLIP
LFE
STEREO
3 When in TONE ON selection, press the TONE key for the follow-
ing displays.
BASS : Select this to adjust the low frequency range.
TREBLE : Select this to adjust the high frequency range.
4 Use the MULTI CONTROL knob or MULTI %/fi keys to adjust the
sound quality.
L
SL S SB SR
C R
SP MUTE
A B CLIP
LFE
STEREO
• The bass and treble levels are adjustable from -10 to +10 in 2 step
increments.
• The adjustment item is displayed for approximately 20 seconds.
• This function is available only for speakers connected to FRONT A
terminals.
Adjusting the LOUDNESS mode
You can adjust the Loudness function which controls the low volume
settings to maintain the music's richness. The adjustment can be made
when the receiver is in the PCM stereo and analog stereo mode.
Press the LOUDNESS key to turn the LOUDNESS setting ON.
• This function is available only for speakers connected to FRONT A
terminals.
To cancel
Press the LOUDNESS key again so that the “LOUDNESS”
indicator goes off.
Input level adjustment (analog sources only)
MULTI CONTROL
SOUND
MULTI %/ fi,
@/#
SOUND
Input
Selector
keys
Input Selector
keys
Input level adjustment (analog sources only)
If the input level of an analog source signal is too high, the CLIP indicator
will blink to indicate the source signal. Adjust the input level.
L
SL S SB SR
C R
SP MUTE
A B CLIP
LFE
CLIP CLIP DOLBY PL II x
1 Use the Input Selector keys to select the source of which the
input level you want to adjust.
• You can store a separate input level for each input source.
2 Press the SOUND and ∧ / ∨ keys or MULTI @/# keys repeatedly
until the “INPUT” indication appears.
3 Use the MULTI CONTROL knob or MULTI %/fi keys to adjust the
input level.
L
SL S SB SR
C R
SP MUTE
A B CLIP
LFE
DOLBY PL II x
• The adjustment mode is displayed for approximately 20 seconds.
• The input level may be adjusted to any one of three settings:
0dB, -3dB, and -6dB. (The initial setting is 0dB.)
4 Press the SOUND key again to return to the input indication.
05.2.8, 11:57 AM 21