Setting oven controls – Kenmore 790.9104 User Manual
Page 8
8
To Set or Change the Temperature for Baking
The oven can be programmed to bake at any temperature from 170°F to 500°F.
To Set the Controls for Baking:
1.
Press
. "— — —°" appears in the display.
2.
Within 5 seconds, press the
or
. The display will show "350°F." By pressing and holding the
or
, the
temperature can then be adjusted in 5°F increments.
3.
When the
or
is released, the oven will begin heating to the selected temperature. When the displayed
temperature reaches the desired baking temperature, the control will beep one (1) time.
4.
To cancel the baking function, press
.
To Change the Oven Temperature after Baking has Started:
1.
Press
and make sure the bake temperature is displayed.
2.
Press the
or
to increase or decrease the set temperature.
Setting Oven Controls
Changing the Temperature Display Mode (some models)
The electronic oven control temperature display mode was factory preset to display (Fahrenheit) °F oven tempertaures.
Note: Oven cooking temperatures may be set from 170°F to 500°F (77°C to 260°C).
To change the Temperature Display Mode to °C (Celsius) or from °C to °F (do not use Bake or Broil while changing
the Temperature Display Mode):
1.
Press & hold the
key pad for 6-8 seconds until
FFFFF
or
CCCCC
appears in the display. Note: At this time the display will
show the current Temperature Display Mode whether set for
FFFFF
or
C
C
C
C
C
.
2.
Press the
key pad once to choose the (Fahrenheit) °F mode; or press the
key pad once to choose the
(Celsius) °C mode.
3.
After 5 seconds, the display will flash. To accept the change, wait 5 more seconds until the oven control beeps once.
To complete the change skip step 4 below, OR;
4.
If at any time during the process of changing the Temperature Display Mode
(
FFFFF
or
CCCCC
) you decide the change is not
desired, press the
key pad before the oven control beeps once to cancel the process.
5.
The control will beep once. The display will then return to the time of day with any temperature display mode change
you may have requested.