Kingston Technology KNE8TX/RS - Manual (Page 14)

Hardware Installation 9
KNE24TX/RS User’s Guide - Rev. A01 Kingston Technology Company
Rear Panel
100-240VAC / 50-60Hz 2.0A Max PWR
OUT
IN
Stackable Module 100FX Fiber Module
100-240VAC / 50-60Hz 2.0A Max PWR
OUT
IN
Stackable Module 100FX Fiber Module
100-240VAC / 50-60Hz 2.0A Max PWR
OUT
IN
Stackable Module 100FX Fiber Module
100BASE-FX Fiber Optic
Plug-in Module
(optional)
Dual Fan Units
Stacking Ports Power
Switch
AC Power
Connector
Fig. 2. Hub Rear Panels with Stacking Cables
Power Switch
The power switch toggles power on and off to the unit. The switch can also be
used to reset the Fast EtheRx hub.
AC Power Connector
The Fast EtheRx hubs use an auto-sensing 100VAC-240VAC, 50/60Hz
internal power supply. Connect the AC power cord from the rear of the unit to
an AC electrical outlet.
WARNING: For safety reasons, DO NOT attempt to open and
service the unit. There are no user-serviceable components
inside.
Fan Units
The Fast EtheRx hubs use two independent cooling fans for optimum air flow
to safeguard the unit from unnecessary heat exposure.
100FX Fiber Module (Optional)
Kingston offers an optional plug-in module to support 100BASE-FX Fiber
Optic cabling. There are two models to support both Straight-Tip (ST) and
Subscriber Connect (SC) type connectors:
• KNE100TX/RST for ST connectors