Kompernass KH 3158 - Manual (Page 22)

24 GB/MT
present! Danger of explosion!
· Do not vacuum up any toner dust!
· Do not cover the vacuum cleaner with other
items! Otherwise it might be damaged by
heat accumulation!
· If you are not using the vacuum cleaner,
please disconnect it from the mains and roll
up the power cord completely! Otherwise
there is a danger of injury if it is tripped
over!
· You should always use the handle when
operating the vacuum cleaner. Vacuuming
up fine dust results in static charges. You
should therefore ensure permanent contact
with the metal insert on the underside of
the handle. This prevents the unpleasant
effects of electrostatic discharge.
· The device should never be used without a
dust bag or filter!
m
Caution!
· Please avoid any damage to the power
cord!
· During use the power cord should be
unwound as far as the yellow marking!
Otherwise there is a danger of damage
from overheating!
· During use the power cord should be
unrolled at least as far as the yellow marking,
but not past the red marking!
· The power cord should only be removed
from the socket by pulling the plug!
· Disconnect the vacuum cleaner from the
mains immediately if there are any
malfunctions!
· If the vacuum cleaner / power cord is
damaged or broken it should only be
repaired by authorised and trained
specialists!
A Initial Use
A Assembly
• Press the cover release { of the dust collec-
tion container and then open the cover.
• Remove the dust bag holder u together with
the dust bag
i
and ensure that the motor
protection filter o and the exhaust air filter
p are assembled as shown in illustration
B. Then reinsert the dust bag holder u
together with the dust bag
i
.
• Close the cover and insert the suction hose
connector } into the suction opening of the
floor vacuum cleaner until it locks in place.
• Insert the tapered end of the telescopic suc-
tion tube R into the connector of the floor
nozzle I until it locks in place. Insert the
handle Q into the telescopic suction tube R
until it locks in place.
a Adjusting the Telescopic Suction Tube
• Keep the height adjuster
Y
held down in the
direction of the arrow (see illustration D).
• Adjust the telescopic suction tube R to the
desired length and lock it in place.
a Using the Suction Nozzles
The floor nozzle
I
is suitable for the daily
vacuuming of carpeted and hard floors. The floor
nozzle
I can be changed over manually - the
brush strip is folded in and out.
• Operate the changeover switch
O
of the
floor nozzle in order to fold out the brush
strip. This setting allows you to vacuum up
loose dust, fluff and hairs on a smooth and
solid surface, e.g. floor tiles.
Safety / Initial Use