Kompernass KH 3158 - Manual (Page 24)

26 GB/MT
A Maintenance and Cleaning
A Maintenance
a Changing the Dust Bag (TYPE KH 99)
You can see that the dust bag i is completely
full when the filling level indicator q in the
viewing window is 100 % RED.
• Turn the vacuum cleaner off and disconnect
the power cord A from the mains.
• Press the release button { on the cover of
the dust collection container and open the
cover.
• Remove the full dust bag i from the dust
bag holder u by pressing the clamping
lever.
• Insert a new dust bag of TYPE KH 99 or type
Swirl ® Y 101 ® into the dust bag holder.
Note:
If no dust bag is inserted it is not possible to
close the cover!
a Changing the Filter
• Switch the vacuum cleaner off and disconnect
the power cord
A
from the mains.
• Press the release button
{
on the cover of
the dust collection container and open the
cover.
• Remove the full dust bag
i
from the dust
bag container
u
by pressing the clamping
lever.
Motor Protection Filter
The motor protection filter
o
protects the motor
compartment against dirt (see illustration B).
• Remove the motor protection filter
o from
the holder.
• Replace the filter insert by another one.
• Then reinsert the motor protection filter
o
in
the holder.
Exhaust Air Filter
The exhaust air filter
p collects fine dusts
which would otherwise be given off to the
surrounding air. The exhaust air filter should be
changed after a visual check (see illustration F).
If a replacement is needed, this can be
purchased from our service addresses.
• Remove the exhaust air filter
p
from the holder.
• Replace the entire exhaust air filter
by a new one.
• Insert the new exhaust air filter p into the
holder and allow it to click into place.
a Thread Catcher
Through the use of the thread catchers on the
underside of the floor nozzle
I , threads and
fluff are vacuumed up particularly thoroughly.
Worn thread catchers can be levered out with an
appropriate tool. If a replacement is needed, this
can be bought from our service addresses.
A Cleaning
• Switch the vacuum cleaner off and discon-
nect the power cord
A
from the mains.
• Please use a dry cloth for cleaning.
• The device should never be cleaned with
moisture!
• Use a brush or tweezers to remove threads
from the floor nozzle
I
, or vacuum these off
from time to time with the crevice nozzle r .
Maintenance and Cleaning