Kawai CN33 - Manual (Page 9)

Page
9
1
P
A
R
T
NAMES AND
FUNCTIONS
‘ HEADPHONES AND USB CONNECTORS
¡ Headphone jack (x 2)
There are two headphone jacks located on the left underside of
the piano.
Up to two pairs of headphones can be connected simultaneously.
„ For information on attaching the headphone hook, please refer
to the assembly instructions on page 66.
¡ USB (to device)
The USB (to Device) connector is located beside the two headphone
jacks, and used to load and save recorder songs to a USB memory
device (page 38).
z BALANCE
The BALANCE slider is used to adjust the
volume balance between the two sounds in
Dual or Split modes, and also controls the
volume of left and right-hand parts of Lesson
songs (pages 15, 17 and 31).
z EFFECTS
The EFFECTS function adds chorus, delay,
tremolo, and rotary speaker simulation
effects to the sound (page 20).
z METRONOME
The METRONOME function provides a
steady beat with which to aid piano practice.
The tempo, time signature, and volume
of the metronome can be freely adjusted
(page 22).
z POWER SWITCH
The POWER SWITCH is used to turn the
CN33 digital piano on and off. Be sure to turn
off the instrument after playing (page 10).
z RECORDER
The REC button is used for recording performances and when using the Lesson
function, to record practices for comparison with the built-in songs and etudes.
The PLAY/STOP button is used to select a song and part to play, and to start/stop
playback of the recorded songs. It is also used to start/stop playback when using
the Lesson function (page 33).
z TRANSPOSE
The TRANSPOSE function allows the audible pitch of the CN33 digital
piano to be raised or lowered in half steps (page 21).
z USB
The USB functions allow recorder songs to be saved to and loaded from
a USB memory device (page 38).
z FUNCTION
Pressing the TRANSPOSE and USB buttons simultaneously enters the
FUNCTION modes, allowing various advanced parameters of the CN33
digital piano to be adjusted (page 43).
z SPLIT
The SPLIT function divides the
keyboard into two sections—
Upper and Lower— allowing
each section to be played with
a different sound (page 15).
z REVERB
The REVERB function adds reverberation
to the sound, simulating the acoustic
environment of a recital room, stage, or
concert hall (page 19).