Kenwood DMF-5020 - Manual (Page 16)

DMF-5020/DMF3020/MD-203 (En)
16
Operation of remote control unit
1
Remove the cover. Insert batteries.
2 3
Close the cover.
÷ IInsert two R03 ("AAA"-size) batteries following
the polarity indications.
Plug the power cord into a power outlet, then turn on the
main unit's POWER key to turn the power on. (If in the
standby mode, press the ON/STANDBY key on the remote
control unit.) Once the power has been switched ON, press
the desired operation key.
Operation
1. The provided batteries are intended for use in operation checking, and their service life may be short.
2. When the remote controllable distance becomes short, replace all batteries with new ones.
3. If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote sensor, malfunction may
occur. In such a case, change the installation position to avoid malfunction.
÷ When pressing more than one remote control keys successively, press
the keys securely by leaving an interval of 1 second or more between
pressing of keys.
Loading batteries
Reference operating range
(Example) Model: RC-M0705
Infrared ray system
Remote sensor
2
1
Notes Notes
6m
30 ° 30 °
÷ Insert two R6 (“AA”-size) batteries following
the polarity indications.
RC-M0705 (For DMF-5020)
RC-M0302
(For DMF-3020/MD-203)