Konexx MOBILE KONNECTOR - Manual (Page 8)

MANUFACTURER MODEL SWITCH
SETTING
AUTO-
DIAL
SEE
NOTE
Toshiba EKT 2000
series
EKT 2000
series
EKT6000
series
Perception
Strata
(Key system )
Strata
(Digital)
103 series
2
2
3 or 4
3
2
1 or 3
2 or 3
Yes
---
Yes
No
---
---
Yes
2
8
1 & 2
1 & 2
Trillium Panther
Talkto 616
2 or 3
2
---
---
1 & 2
1 & 2
Vodavi Electronic
Key System
See Note Yes 7
Walker Marathon
Poet
1 or 4
1
Yes
Yes 1
If your telephone does not allow autodialing, you can still communicate by dialing with the keypad on your telephone. Refer to the directions for Dialing data or
fax calls manually..
NOTES:
1. Some versions of this phone may not work on the listed switch setting and may not be compatible with the Mobile Konnector. Contact Technical Support
to verify that your setup is correct and to determine if the Mobile Konnector is compatible with your phone.
2. Sufficient data is not available as to whether the phone system will support autodialing with the Mobile Konnector.
3. The Mobile Konnector will not support autodial on Model 7300 telephones.
4. You may have to dial an outside access number, such as a 9, on the telephone before autodialing.
5. This telephone has nonstandard handset wiring and is not compatible with the Mobile Konnector.
6. When autodialing the user must dial a number on the keypad of the telephone set to maintain the line.
7. The Mobile Konnector is not compatible with this phone set.
Using Your Mobile Konnector with your Modem
After You have connected the Mobile Konnector to your phone and set the proper switch setting you are now ready to use the
Mobile Konnector to dial out to get your Email, send a FAX, attach to your office network, or simply browse the Web.
If you use the Mobile Konnector while traveling it is recommended that you follow the instructions immediately below;
however if you are using the Mobile Konnector on one main phone system, check to see if your phone system can
support auto-dialing (refer to the switch setting section and phone chart). If auto-dialing is supported, jump to the
auto-dialing section.
Dial out with the Mobile Konnector
Since you are not connected to a standard analog phone line, you will dial out by dialing the phone number on your phone
directly then once the other end answers your modem will be able to connect. Follow the steps below to initiate the call:
1. Prepare your modem, fax/modem, or fax machine for sending.
2. Lift the telephone handset from the receiver then have your modem dial by clicking on Connect or Send. All this is doing is
initiating the modem to do a connection, the number you are dialing is not really being passed through to the phone carrier.