Kustom KXB100 - Manual (Page 5)

1. 0 dB Input: ¼-inch input that is intended for bass guitars with standard, passive electronics.
2. –6 dB Input: ¼-inch input that is optimized for bass guitars with active electronics.
3. Gain: Controls the input level to the preamp. Set so Clip indicator light is not lit, otherwise distortion may occur.
4. Volume: Controls the overall volume level of the amplifier. Use in conjunction with the Gain control to obtain the
desired level.
5. Bass: This active control adjusts the lower frequencies to provide rich, full bass tones. It will boost or cut by 14 dB at
60 Hz.
6. Lo-Mid: This control adds thickness and body to your tone. It will boost or cut by 12 dB at 340 Hz.
7. Hi-Mid: This control adds punch to your overall tone. It will boost or cut by 10 dB at 2 kHz.
8. Treble: Increasing this control will add presence and attack to your bass tone. It will boost or cut by 15 dB at 10 kHz,
perfect for enhancing “slap” and pick playing.
9. Aux In: This is a 3-conductor, 1/8-inch, stereo jack that allows playback from a Compact Disc, MP3 player or other
audio device. The overall volume level will be determined by the audio device, so start with lower volume levels and
increase as needed.
10. Headphones: This is a 3-conductor, 1/8-inch input jack intended for headphone use. The amplifier’s internal speaker
is disconnected when this jack is used.
11. Power Switch: This dual-function component is both an On/Off power switch and a status indicator light. When
illuminated, it shows that your amplifier is ready to be played. To turn amplifier on, press switch upward. To turn amp off,
press switch downward.
KXB100
1 2 3 4 6 7 8
kustom.com
5 10 9 11
KXB100 Control Panel