Kxb100 back panel – Kustom KXB100 User Manual

Page 6

Advertising
background image

kustom.com

KXB100

Power Cord: This supplies AC power to the amplifier. If the cord becomes damaged, take the amplifier to an authorized
service center for repair.

External Speaker: This is a two-conductor, ¼-inch external speaker jack. (Note: This jack is wired in series with the
amp’s internal speaker. Therefore, the internal speaker still functions when an external speaker cabinet is added. For this
reason, there is no minimum external speaker impedance load.)

Effects Loop Send: Use this 2-conductor, ¼-inch jack to connect to the input of an external effects processor or
equalizer. This jack can also be used as a Preamp Out.

Effects Loop Return: Use this 2-conductor, ¼-inch jack to connect to the output of an external effects processor or
equalizer. This jack can also be used as a Power Amp In.

Balanced Line Out: This XLR jack is used to connect the amplifier to a mixer or other line level amplifier. (Note: This
output is post-EQ and post- Effects Loop but is located before the Volume control.)

Direct Out Volume: This control sets the output level for the Balanced Line Out. Set in its lower ranges until necessary
volume has been determined.

Ground Lift: Activating this switch removes the ground connection on the Balanced Line Out jack. If necessary, use this
switch to eliminate hum.

KXB100 Back Panel

Advertising