Kawasaki MULE 600 SERIES - Manual (Page 5)

Rev. G
p. 5 of 9
5. INSTALL LEFT SIDE FRAME
5.1 Position the left side frame as shown in Fig. 5.1.
Important: place the front of the side frame over the
front of the cab bar system and pivot the rear of the
side frame into place so that the rear leg of the side
frame installs behind the rear roof mount which was
just installed in step 4. If installing a hard sided cab,
the rear leg of the side frame is to be in front of the rear
window. NOTE: make sure the ball stud mount, which
is for the windshield gas shock, is over the cab bar tube
before pivoting into place. Ref.: handle with care so the
Expand-a-foam does not get distorted or damaged
while pivoting.
5.2 Bolt the rear leg of the side frame to the rear roof
mount two places as shown in Fig. 5.2. Use 3/4” long
carriage bolts.
5.3 Bolt the front of the side frame to the front
mounts two places as shown in Fig. 5.3. Use 3/4” long
carriage bolts.
5.4 The right side frame will be installed after the
windshield support is installed in the next step on the
next page (step 6.1).
NOTICE: rear leg of side
frame must be behind the
rear roof mount
locknuts to be on
inside surface of cab
Fig. 5.2
(view from front
of driver’s side)
ref.: ball stud mount
is inside the side
frame in this vicinity
Fig. 5.1
(view from driver’s side)
Expand-a-foam strip
Fig. 5.3
(view from front
of driver’s side)
bolt heads on this
outside surface