Kambrook KQK600 - Manual (Page 7)


CARE AND CLEANING
Always switch off at the power outlet, and then
unplug the appliance from the power outlet before
cleaning.
Note: Ensure the kettle and water have cooled
down before attempting to clean the kettle.
REMOvAL OF MINERAL DEPOSITS
Mineral deposits in tap water may cause the
interior and water gauge to discolour over time. This
may be removed by the following way.
Fill the Hot Cup until 2 ⁄
3
full with 1 part vinegar
and 2 parts water. Mix them in a vessel before
pouring into the water chamber of the Hot Cup.
Boil and allow to stand overnight.
Empty the solution from the Hot Cup. Fill with
clean water, bring to boil and discard the water.
Repeat and the Hot Cup will be ready for use.
TO CLEAN THE ExTERIOR
The outside of the Hot Cup may be wiped over with
a damp cloth and polished with a soft, clean dry
cloth.
Empty the drip tray. Wash the drip tray and drip
tray cover in warm soapy water. Rinse and dry
thoroughly before placing them back to the power
base.
Note: Do not use kettle descaler, chemical, steel
wool, or abrasive cleaners to clean the inside or
outside of the Hot Cup.
STORAGE
Ensure the kettle is switched off, cleaned and dried
before storing. Ensure that the lid is closed and
locked securely into place. Wrap the power cord
around the cord storage under the power base.
Stand the kettle upright on the power base. Do not
store anything on top.
 WARNINg: TO PREVENT DAMAgE TO THE APPLIANCE, DO
NOT uSE ALKALINE CLEANINg AgENTS WHEN CLEANINg. uSE A
SOFT CLOTH AND MILD DETERgENT.
 WARNINg: NEVER IMMERSE THE HOT CuP bASE, SWITCH
AREA, POWER bASE OR POWER SuPPLy CORD IN WATER, OR
ALLOW MOISTuRE TO COME IN CONTACT WITH THESE PARTS.
1.
2.
KQK600_HOTCUP_IB_FA.indd 7 19/6/09 4:00:18 PM