Kambrook KFH540 - Manual (Page 8)

8
Using Your Low Profile Fan Heater
Setting the Heating Mode
and Variable Temperature
To control the heater, turn the Heat
Setting dial and Variable Thermostat
dial as follows.
The Heat Setting dial has 4 modes:
OFF - Shuts off the heater and fan
FAN
- For fan only operation
1 - Low heat setting (1200 watts)
2 - High heat setting (2400 watts)
The Variable Thermostat dial acts as
an automatic thermostat and can
be used to maintain your desired
temperature.
Turn the Heat Setting dial to setting
2 and the Variable Temperature dial
to MAX setting. Once a comfortable
room temperature has been reached,
slowly turn the Variable Temperature
dial anti-clockwise until a click sound
is heard.
At this setting your heater will
automatically cycle on and off
to maintain the desired room
temperature
Turn the heater off by turning the Heat
Setting dial to the OFF position.
Before First Use
Remove any promotional material
and packaging from the heater.
Unwind the cord to its full length
and place the heater on a firm, level
surface in a stable, upright position.
Visually inspect the air inlet and outlets
to ensure there are no blockages.
Turning Your Heater On
Ensure the Heat Setting dial is turned
to the OFF position and Variable
Thermostat dial to “MAX”.
Plug the cord into a 230V or 240V
power point and switch on.
NOTE: To avoid an electrical
circuit overload, it is
recommended that no other
appliances are plugged into
the same circuit as your heater,
when it is in use.
The Power-On Indicator, on the front
of the heater, will illuminate when the
heater is turned on.
KFH540_IB_FA.indd 8 12/10/09 11:07 AM