Kuppersbusch USA IKE339-1 - Manual (Page 4)

Environment Protection
This appliance does not contain gasses
which could damage the ozone layer, in
either its refrigerant circuit or insulation
materials. The appliance shall not be dis-
carded together with the urban refuse
and rubbish. The insulation foam con-
tains flammable gases: the appliance
shall be disposed according to the ap-
plicable regulations to obtain from your
local authorities. Avoid damaging the
cooling unit, especially at the rear near
the heat exchanger. The materials used
on this appliance marked by the symbol
are recyclable.
Control panel
1 2 3 4 5 6 7
1 Fridge Pilot light
2 Fridge ON/OFF switch
3 Fridge temperature regulator, + button
4 Fridge temperature indicator
5 Fridge temperature regulator, - button
6 Supercool indicator
7 Supercool button
Switching on the fridge
1. Insert the plug into the mains socket.
2. Press ON/OFF switch .
3. The Pilot Light will light up.
Switching off the fridge
1. Keep ON/OFF switch pressed for more
than 5 seconds.
2. After that, a countdown of the tempera-
ture from -3 -2 -1 will be shown. When
“1” appears the fridge is turned off. The
temperature indicator switches off. The
Pilot light switches off.
Temperature setting buttons
The temperature is adjusted using the tem-
perature setting buttons. These buttons are
connected to the temperature indicator.
• The temperature indicator is switched over
from the indicator of the ACTUAL temper-
ature (Temperature indicator is illuminated)
to the indicator of the DESIRED tempera-
ture (Temperature indicator flashes) by
pressing one of the Temperature setting
buttons.
• Each time one of the two buttons is press-
ed again the DESIRED temperature is ad-
justed by 1°C. The DESIRED temperature
must be reached within 24 hours.
If neither button is pressed, the temperature
indicator automatically switches back after a
short period (approx. 5 sec.) to the indicator
of the ACTUAL temperature.
DESIRED temperature means:
The temperature that has been selected for
inside the fridge. The DESIRED temperature
is indicated by flashing numbers.
ACTUAL temperature means:
The temperature indicator shows the current
temperature inside the fridge. The ACTUAL
temperature is indicated with illuminated
numbers.
Temperature indicator
The temperature indicator shows several in-
formation:
• During normal operation, the temperature
currently present in the fridge (ACTUAL
temperature) is displayed.
• When the temperature is being adjusted a
flashing display indicates the fridge tem-
perature currently set (DESIRED tempera-
ture).
When changing the temperature setting wait
about 24 hours until the temperature display
has stabilised.
4