Kobe Range Hoods CH8036SQ - Manual (Page 6)

5
5) Use 2 long screws (included) to secure the Exhaust Duct Cover Position Panel to the wall.
This will help keep the Exhaust Duct Cover in place. Repeat to secure second positioning
panel for extended portion of duct cover. (Fig. 3a)
Mounting Screws
{Fig. 3} {Fig. 3a}
6) Fasten duct cover to hood by using a short screws (included).Make sure the screw goes into
the plastic receiving end on the hood. Do the same for the other side of the duct cover.
(Fig. 3b)
{Fig. 3b} Screws on both sides
7) Slide oval oil container into plastic slot behind each safety screen (Fig.3c). And Attach round
oil container under each safety screen. Turn clock-wise until firmly in place (Fig.3d).
Round Oil Container
{Fig. 3c} {Fig. 3d}
Oval Oil container
For Installation of Additional KOBE Exhaust Duct Covers (Optional)
If installing additional KOBE Exhaust Duct Cover to extend duct cover beyond 27
½” :
1) Pull out inner section of KOBE Exhaust Duct Cover and remove protective film before
installing. Reinsert the inner duct cover section.
2) Depending on additional length needed, adjust the duct cover to the desired length (14 1/8
”
to 27 ½” ) and place a short screw (included) through the oblong opening and hole on duct
cover. This will secure the duct cover at the desired length. Insert the inner section of
additional two piece duct cover to outer section of included two piece duct cover and secure
with two short screws. (Fig. 4).