Kettler 08838-399 - Manual (Page 3)

3
environment.
■ Lubricate the bearing sleeves of the wheels and the handlebars with a few drops of oil every two or three months.
■ Due to the nature of materials used in pneumatic tires on KETTLER ® toys, it is not recommended for the product to be
left in any one place for too long where solvents or other chemicals, i. e. petrol, may lie. This may result in a chemical
reaction, which could cause the tires to mark the surface such as a vinyl flooring. If in doubt put something underne-
ath the wheels to cover the floor.
■ For models with push bars: Always ensure that the push bar fits correctly in the adaptor, and locks. Do not hang
any weights on the bar! The vehicle may tip over, and your child may be hurt. The push bar is intended for adult
use only, do not pass responsibility for children on to other children. For free play time take the push bar off for
safety reasons.
Assembly of the toy vehicle
■ The toy vehicle must be assembled carefully by an adult person. Study the assembly instructions carefully before begin-
ning work. Assemble the vehicle in the exact sequence shown by the letters in the diagrams. This is essential for the
safe function and use of the tricycle.
■ Please note that there is always a danger of injury when working with tools or doing manual work. Therefore please
be careful when assembling this machine.
■ Ensure that your working area is free of possible sources of danger, for example don’t leave any tools lying around.
Always dispose packaging material in such a way that it may not cause any danger. There is always a risk of suf-
focation if children play with plastic bags!
■ Bolt all the parts together loosely at first, and check that they have been assembled correctly. Tighten the locknuts by
hand until resistance is felt, then use wrench to finally tighten nuts completely against resistance (lock-
ing device). Then check that all screw connections have been tightened firmly. Attention: once locknuts have been
unscrewed they no longer function correctly (the locking device is destroyed), and must be replaced.
■ The grips can be pushed onto the handlebars more easily if they are first soaked in warm water.
■ Please keep original packaging of this article, so that it may be used for transport at a later date, if necessary.
Goods may only be returned after prior arrangement and in (internal) packaging, which is safe for transporta-
tion, in the original box if possible. It is important to provide a detailed defect description / damage report!
■ For technical reasons, we reserve the right to carry out preliminary assembly work (e.g. addition of tubing plugs).
■ When ordering spare parts, always state the full item number, spare-part number, the quantity required and the seri-
al number of the product..
Example order: item # 08838-399 / spare part no. 12802003 / 1 piece/ S/N ...
Important: spare part prices do not include fastening material; if fastening material (bolts, nuts, washers etc.)
is required, this should be clearly stated on the order by adding the words „with fastening material“.
KETTLER limited warranty
THERE ARE NO WARRANTIES, EXPRESSED OR IMPLIED, MADE BY EITHER THE DISTRIBUTOR OR THE
MANUFACTURER ON KETTLER PRODUCTS, EXCEPT THE MANUFACTURER’S LIMITED WARRANTY
AGAINST DEFECTS IN MATERIAL SET OUT BELOW:
This KETTLER Limited Warranty applies to products sold through the KETTLER Authorized Dealer Network
to the original retail purchaser and authenticated by proof of purchase from a retailer located in the
United States. Any shipments made under this warranty will be shipped to the United States only. Any
shipment outside of the United States will be at the sole cost of the customer. This KETTLER Limited
Warranty is a manufacturer’s warranty and is not changed or modified by additional warranties extended
by individual retailers at the point of sale. Manufacturer warrants this product to be free from defects in
material at the time of the product’s tender of delivery for a period of 3 years for residential use and 1
year for non-residential use. This Limited Warranty is not transferable and does not cover normal wear
and tear (including, but not limited to, damage and wear to tires, power shocks, drive belts and other
non-durable parts). The liability of the manufacturer under this Limited Warranty shall not include any lia-
bility for direct, indirect, or consequential damages resulting from the defect. This Limited Warranty is
void if the product is damaged by accident, unreasonable use, improper service, failure to follow instruc-
tions provided, modification from its original state, or other causes determined not arising out of defects in
material.
This warranty gives you specific legal rights. Should this product become defective due to material within
the warranty period, contact KETTLER Parts & Service Dept. by phone at 866.804.0440, fax at
757.563.9273, or e-mail at [email protected].
THIS LIMTIED WARRANTY IS EXPRESSLY IN LIEU OF ANY OTHER WARRANTIES, EXPRESSED OR
USA