KTI Networks KCD-302 Series - Manual (Page 10)

-10-
Configuration Setting Switches (SW)
NO. FUNCTION SETTINGS
SW1 TP Port mode OFF Auto-negotiation (default)
ON Forced mode
SW2 TP Port Duplex OFF Full duplex (default)
ON Half duplex
SW3 TP Port Speed OFF 100Mbps (default)
ON 10Mbps
SW4 802.3x function OFF Enable (default)
ON Disable
SW5 FX1 port duplex OFF Full duplex mode (default)
ON Half duplex mode
SW6 FX2 port duplex OFF Full duplex mode (default)
ON Half duplex mode
LED Indicators
LED DISPLAY STATE INTERPRETATION
PWR Power status ON Power on
OFF Power off
TP LINK TP port link status ON Link up and no traffic
OFF Link fault
BLINK Rx/Tx activities
TP 100M TP port speed status ON 100Mbps
OFF 10Mbps
TP FDX TP port duplex status ON Full duplex
OFF Half duplex
BLINK Collisions on half duplex
FX1 LINK FX1 port link status ON Link up and no traffic
OFF Link fault
BLINK Rx/Tx activities
FX1 OL FX1 port optical link ON Optical signal is detected
OFF No optical signal
FX2 LINK FX2 port link status ON Link up and no traffic
OFF Link fault
BLINK Rx/Tx activities
FX2 OL FX2 port optical link ON Optical signal is detected
OFF No optical signal