Kompernass KH 2370 - Manual (Page 11)

10 KH 2370 11 KH 2370
Preparing the
combination unit for
operation
Remote control
1 Open the battery compartment on the back of the re-
mote control and remove the cover of the
battery comparment.
2 Now put in two batteries type AAA/LR 03 (round cells,
not included in the scope of supply) into the battery
compartment. Take care that the batteries are inserted
with the correct polarity.
3 Put the cover of the battery compartment back on to
the back of the remote control.
Replacing the batteries:
If the combination unit cannot be operated properly with
the remote control or does not work at all, the batteries
must be replaced.
Always replace both batteries, in order to be able to use
the remote control at full capacity again.
Note:
Used batteries may not be disposed of in household
waste. Throw away used batteries at a waste collection or
disposal point or there, where you bought the batteries.
If you should want to dispose of the remote control of
the combination unit itself, then you have to remove the
batteries beforehand!
Note
To guarantee that the remote control works perfectly:
• Always point the remote control at the combination
unit
• Ensure that there are no obstacles between the re-
mote control and the combination unit, which pre-
vent reception
• Do not move more than 5 meters away from the
combination unit when using the remote control
Otherwise disturbances can arise when operating the
combination unit with the remote control.
Connecting the combination unit to a
television
After having set up the combination unit, you can now
connect it to a television. The combination unit can be
connected to a television with PAL, NTSC and SECAM tel-
evision standards.
If you would like to use the combination unit with a televi-
sion with
• NTSC standard, then you have to change the video set-
tings of the combination unit. This can be done in the
so-called OSD menu of the combination unit. There
you will find that PAL has been set by the factory as the
television standard.
• SECAM standard, then you do not have to make any
changes to the settings in the OSD menu. The settings
for the PAL standard also enable the combination unit
to be operated with SECAM television sets. However to
do this, SECAM televisions sets must be able to process
PAL signals.
Depending on the type of television, there are different
possibilities of connecting the combination unit to it:
Connecting to a television by means of
a scart cable/RGB
Note:
The best quality connection is achieved by connecting the
combination unit to the television by means of a scart ca-
ble via the RGB input. Choose this connection variant if the
television has an RGB input. If you are not sure, check this
by looking at the operating instructions of the television.
To connect the combination unit to a television by means
of a scart cable:
1 Plug the supplied scart cable into the scart jack of the
combination unit.
2 Plug the other end of the scart cable into the scart jack
of the television.
3 Set the television to RGB mode in the AV channel. If
you are not sure how to carry out this setting, then
consult the operating instructions of the television.
Also look at the chapter “Setting video output” for more
information on this subject.