Kenwood XD-700 - Manual (Page 7)

XD-750/700/550/500 (En)
7
Preparation section
Basic section
Application section
Knowledge sections
− +
3 3
1 1
1. In case an associated system compo-
nent is connected, also read the instruc-
tion manual of the component.
2. Never short-circuit the + and – speaker
cords.
3. If the left and right speaker connections
or the + and – polarity are inverted, the
sound will be unnatural with unclear
positioning of musical instruments, etc.
Be sure to connect them without mis-
take.
1. Be sure to insert all connection cords
securely. If their connections are imper-
fect, the sound may not be produced or
noise may interfere.
2. Before plugging or unplugging a con-
nection cord, be sure to unplug the
power cord from the wall AC outlet. If
connection cords are plugged or un-
plugged with the power cord left plugged
in, malfunction or damage may result.
Notes Notes
Twist
Notes Notes
Speaker Unit
Caution regarding placement
To maintain proper ventilation, be sure to leave a space around
the unit (from the largest outer dimensions including projec-
tions) equal to, or greater than, shown below.
left and right panels: 10 cm, rear panel: 10 cm, top panel: 50 cm
FM indoor antenna
The accessory antenna is for temporary indoor use only. For stable signal
reception we recommend using an outdoor antenna. Remove the indoor
antenna if you connect one outdoors.
1Locate the position providing good reception condition.
2Fix the antenna.
System connection
Speaker (left)
3 2 1 4
Front View
The external view is variable depending on the model and
marketing destination type.