Before applying power, Safety precautions, For the united kingdom – Kenwood XD-700 User Manual

Page 2

Advertising
background image

XD-750/700/550/500 (En)

2

Preparation section

Basic section

Application section

Knowledge sections

Before applying power

Units are designed for operation as follows.

Europe and U.K. ........................................................................ AC 230 V only

Factory fitted moulded mains plug

1.The mains plug contains a fuse. For replacement, use only a 13-

Amp ASTA-approved (BS1362) fuse.

2.The fuse cover must be refitted when replacing the fuse in the

moulded plug.

3.Do not cut off the mains plug from this equipment. If the plug

fitted is not suitable for the power points in your home or the ca-
ble is too short to reach a power point, then obtain an appropriate
safety approved extension lead or adapter, or consult your dealer.
If nonetheless the mains plug is cut off, remove the fuse and dis-
pose of the plug immediately, to avoid a possible shock hazard by
inadvertent connection to the mains supply.

IMPORTANT: The wires in the mains lead are coloured in accord-

ance with the following code:

Blue

: Neutral

Brown : Live

Do not connect those leads to the earth terminal of a three-pin
plug.

For the United Kingdom

The marking is located on the rear panel and says that the compo-
nent uses laser beams that have been classified as Class 1. It means
that the unit is utilizing laser beams that are of a weaker class. There
is no danger of hazardous radiation outside the unit.

CLASS 1

LASER PRODUCT

The marking of products using lasers

(Except for some areas)

REQUIREMENT BY NEDERLAND GAZETTE

Safety precautions

WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO

RAIN OR MOISTURE.

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALI-
FIED SERVICE PERSONNEL.

RISK OF ELECTRIC SHOCK

DO NOT OPEN

THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED
TO ALERT THE USER TO THE PRESENCE OF UNINSULATED “DANGEROUS VOLTAGE” WITHIN THE
PRODUCT’S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELEC-
TRIC SHOCK TO PERSONS.

THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO
THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE
LITERATURE ACCOMPANYING THE APPLIANCE.

CAUTION

Batteries are supplied with this product. When
they empty, you should not throw away. Instead,
hand them in as small chemical waste.

Caution : Read this page carefully to ensure safe operation.

Advertising
This manual is related to the following products: