Kodak PDV-70X - Manual (Page 39)

Troubleshooting
33
No sound Audio cable(s)
not securely
connected Make sure the audio signal cable(s) are
firmly connected.
Headphones
plugged in Unplug the headphones.
Audio muted Unmute the audio by pressing the MUTE
button on the remote.
Display is too
dark or too
bright Contrast or
brightness too
low or too
high Adjust the contrast and/or brightness to
desired setting.
Remote
control not
functioning Battery
inserted
improperly Make sure the battery is inserted and
oriented properly.
Battery low on
energy Replace the battery.
A button is
stuck Jog any stuck buttons on the remote to
unstick them.
Obstacle
between
remote and
display Remove the obstacle.
The remote is
too far from
the display Move closer to the display.
After-image
remains on
screen after
display is
turned off Inherent LCD
characteristics This is characteristic of an LCD. The after-
image will disappear after a few minutes.
Distorted
image Display format
set incorrectly Check that the correct display format is
selected in the Setup menu.
Red, green,
blue, or
white dots
on screen Inherent LCD
characteristics This is characteristic of an LCD and will not
cause a malfunction.
Symptom Possible
Cause Resolution
OMPDV70X.book Page 33 Sunday, May 28, 2006 8:45 PM