Kenwood DPX-6020 - Manual (Page 8)

— 8 —
English
You can adjust the panel angle for easy viewing.
Sliding the panel:
Press the ANGLE ∞ button.
Each time you press the ANGLE ∞ button, the panel will slide
one step at a time.The faceplate angle can be varied in up to
ten steps.
If the power is turned off, the panel will close automatically.
When you turn the power back on, the panel angle will return to
the adjusted angle position.
Closing the panel:
Press the 5ANGLE RTN button to close the panel.
The sound will be muted while the panel is sliding during the tape
mode.
• Take care that your fingers and so on do not get caught during
the slide operation of the front panel.
• When the front panel has been slid, it might interfere with the
shift lever or something else. If this happens, pay attention to
safety and move the shift lever or take an appropriate action,
then operate the unit.
• Do not apply excessive force to the front panel after it slides.
2CAUTION
NOTE
NOTE
Panel Angle Adjustment
You can switch the display during the standby mode as
mentioned below.
Switching the Display During the Standby Mode:
Each time you press the DISP button during the standby mode,
the display switches as follows:
Character with graphic display
Clock with graphic display
Clock
Switching Display
General features
DPX-6020_K_U.S 01.12.25 1:57 PM Page 8