KVH Industries TracVision R4 - Manual (Page 25)

4. Terminate all unused output connectors with
75 ohm DC blocks (Channel Master #7184, Radio
Shack #15-1259 or equivalent).
2.3.6 Sealing the Cable Access Hole
Once the RF and data/power cables are connected to the
antenna, you need to seal and cover the cable access hole to
protect against leakage.
1. Completely seal the cable access hole with silicone
sealant or RTV.
2. Install the clamshell ventilator, supplied in the
kitpack, over the cable access hole using the three
supplied #6 screws (see Figure 2-16).
2.4 Activating the Receiver
DIRECTV and DISH Network Receiver Activation
KVH makes it easy to activate your DIRECTV or DISH Network
receiver. Just call KVH at 1-888-584-4163 and ask for Receiver
Activation
(Monday - Friday, 8:30 a.m. - 5:00 p.m. ET). For other
options, please refer to the user manual that accompanied your
receiever.
Other Receiver Activations
Please refer to the user manual that accompanied your receiever
for activation instructions.
2-14
A Guide to TracVision R5/R4
Clamshell
Ventilator
#6 Screws
Cable Access Hole
(in Roof of Vehicle)
RF & Data/Power
Cables
To
Tra
cV
isio
n
An
ten
na
Figure 2-16
Installing the Clamshell Ventilator
Ensure the clamshell mounting
screws do not puncture the cables
inside the vehicle.