KVH Industries TracVision R4 - Manual (Page 46)

If the satellite signal is lost while the system is in conical scan
track mode, the control software imposes a 45-second time-out
delay. If the signal is not regained during that time, the antenna
reverts to the set of Search Modes to start looking for the satellite
signal. This is an automatic process that does not require user
intervention.
3.4 DISH 500 Mode
DISH Network customers with DISH 500 service and a DishPro
301 receiver may configure the TracVision R5/R4 system to use
DISH 500 mode. DISH 500 mode automatically switches between
the Echo 119 and Echo 110 satellites when the channel is changed
using the receiver’s remote control.
Configuring the Antenna for DISH 500 Mode
To configure the TracVision antenna for DISH 500 mode, you will
need to run the receiver’s Check Switch function twice. You do
not
need a laptop computer.
To configure the TracVision antenna for DISH 500 mode, follow
the steps below.
1. Park your vehicle in a blockage-free area and do
not move the vehicle until you have completed the
entire configuration process.
2. Turn on the master receiver (the receiver that is
connected to the antenna’s RF1 connector) and the
television.
3. Turn on the TracVision antenna using the
switchplate’s power switch.
4. Wait one minute for the antenna to initialize.
5. Using the receiver’s remote control, go to the
“Point Dish/Signal Strength” screen (press Menu,
6, 1, 1 (on most models)).
6. Using the remote control’s arrow buttons,
highlight “Check Switch” and press the Select
button.
7. Highlight “Test” and press Select.
3-8
A Guide to TracVision R5/R4
N E T W O R K