Kodak Ektapro Slide Projector 4020 - Manual (Page 62)

CENTER HOUSING
1 . Remove the UPPER HOUSING. See page 4-1.
2 . Remove the FOCUS INDICATOR.
3 . Release the HOLDING CLIP at the KEYBOARD and remove the PCB.
4 . Release the HOLDING CLIP at the TRAY MOTION PCB and remove the PCB.
5 . Remove the SPRING and the ZERO LEVER. See figure 4-7.
6 . Remove the 8 RETAINERS and 8 ROLLERS. See figure 4-7.
7 . Remove the DRIVE RING. See figure 4-7.
8 . Remove the 3 SHAFT ROLLERS and the 3 BEARING ROLLERS. See figure 4-7.
KEYBOARD PCB
KEYBOARD
HOLDING CLIP
FOCUS
INDICATOR
TRAY
MOTION
PCB+
HOLDING
CLIP
figure 4-6
Service Manual SM2547-1
03/98 4-4 Kodak AG, Stuttgart