Kodak Ektapro Slide Projector 4020 User Manual
Page 69
TRANSFORMER, POWER SUPPLY PCB and BACK PLATE ASSEMBLY
NOTE
It is easier to remove the complete TRANSFORMER, POWER SUPPLY PCB and BACK PANEL ASSEMBLY
at the same time, to avoid needless removals.
1
.
Remove the UPPER HOUSING. See page 4-1.
2
.
Remove the CENTER HOUSING. See page 4-4.
3
.
Remove the 4 SCREWS from the TRANSFORMER
4
.
Remove the CONNECTOR P3 from the POWER SUPPLY PCB.
5
.
Remove the NEUTRAL WIRE at the MECHANISM FRAME and the LAMP HOUSING ASSEMBLY.
6
.
Disconnect POWER SUPPLY PCB from the MASTER BOARD PCB. Remove the TRANSFORMER and
the BACK PLATE ASSEMBLY.
7
.
If needed, install new assemblies.
LAMP HOUSING ASSEMBLY
BACK PLATE ASSEMBLY
NEUTRAL
WIRES
CONNECTORS(P3)
POWER
SUPPLY
PCB
TRANSFORMER
SCREW (4)
figure 4-16
SM2547-1
Service Manual
Kodak AG, Stuttgart
4-11
03/98