Kathrein UFS 712sw - Manual (Page 35)

35
Use the

buttons to switch to the selection fi eld “End” and use the

buttons to select
the desired recording fi nishing time.
When all settings have been made, press the button to save the recording settings. You can view
the scheduled recording in the recording schedule view of the EPG (see item “Recording schedule”).
SERIES RECORDING
Use the

buttons to select the recording mode “Series recording”.
In series recording the start and fi nish of recording are taken automatically by the receiver from
the EPG data. You can only specify a lead-in and run-out time to be sure to record the complete
programme even if transmission times may vary slightly. The setting of lead-in and run-out time
is done using the

buttons or the keypad.
When all settings have been made, press the button to save the recording settings. You can view
the scheduled recordings in the recording schedule view of the EPG (see item “Recording schedule”).
Series recording depends on the EPG data being kept up to date at all times. The
receiver automatically updates the EPG data when the unit is switched off by pressing
the

button. Updating is important because it enables the receiver to recognise
for purposes of recording any changes to scheduled transmission times of the
series, provided these were incorporated in the EPG data supplied by the channel
provider in advance of the latest EPG update.
EPG - ELECTRONIC PROGRAMME GUIDE