La Crosse Technology WS-7026U - Manual (Page 18)

18
5. Screw mounting bracket onto the mounting surface. The screws should
be flush with the bracket.
6. Fit the mounting post (on the back of the sensor) into the receptor of
the mounting bracket.
B. MOUNTING WITH ADHESIVE TAPE
1. With a nonabrasive solution, clean and dry the back of the mounting
bracket and the mounting surface to ensure a secure hold. The
mounting surface should be smooth and flat.
2. Remove the protective strip from one side of the tape. Press firmly
onto the designated area on the back of the mounting bracket.
3. Remove the protective strip from the other side of the tape and situate
the mounting bracket. Firmly press the mounting bracket onto the
mounting surface.
4. Fit the mounting post into the receptor of the mounting bracket.
II. THE INDOOR TEMPERATURE STATION
The Indoor Temperature Station can be mounted in two ways:
• with the table stand or
• on the wall with the use of a wall hanging screw (not included).
A. USING THE TABLE STAND
1) The Indoor Temperature Station comes with the table stand already
mounted. If you wish to use the table stand, all that is required is to place
the Indoor Temperature Station in an appropriate location.
B. WALL MOUNTING
1) Remove the table stand. To do this, pull down on the stand from the rear
and rotate forward.
2) Fix a screw (not included) into the desired wall, leaving approximately 3/16
of an inch (5mm) extended from the wall.