La Crosse Technology WS-7026U - Manual (Page 6)

6
PROGRAM MODE
Programming Note: If 30 seconds is allowed to pass or either the IN or the
OUT button is pressed during programming modes, the unit will set the last
information entered—the display will stop flashing and return to normal
time-date readings. If you don’t leave the program mode during the
programming of sections III through VIII, you can advance to step 3 of the
next program setting. If you do leave the program setting (or want to
program a specific setting) follow each instructional step to program that
setting.
I. FUNCTION KEYS
The function keys are operated by pressing the top or bottom of the key
corresponding to the operation that you want to perform.
II. 12 OR 24 HOUR TIME SETTING
1. Press and hold the SET button for 3 seconds or until “12 h”
flashes in the DATE LCD.
2. Press the CH button to toggle between 12 and 24-hour time.
3. Press the SET button to confirm the 12/24-hour setting and to
advance to Time Zone Setting.
III. TIME ZONE SETTING
The default time zone is EST “-5hr” (Eastern Standard Time). To
change this setting:
1. Press and hold the SET button for 3 seconds or until “12 h”
OR “24 h” flashes in the DATE LCD.
2. Press the SET button 1 more time to enter the Time Zone
setting mode. The default Time Zone “-5” will flash in the
DATE LCD.
3. Select your appropriate time zone using the CH button.
During selection of the Time Zone, the 3 letter abbreviations
for the time zones found in North America will flash across