LevelOne GSW-1675T - Manual (Page 19)

IDENTIFYING EXTERNAL COMPONENTS
This chapter describes the front panel, rear panel, and LED indicators
of the Switch.
Front Panel
The figure below shows the front panels of GSW-1675T.
Figure 4. Front panel of 16-port Gigabit Ethernet Switch
LED Indicator:
Comprehensive LED indicators display the status of the switch and
the network (see the LED Indicators chapter below).
Gigabit Ethernet Ports (Port 1~16):
GSW-1675T sixteen Gigabit twisted pair ports, supported auto negotiable
10/100/1000Mbps and auto MDI/MDIX crossover detection function, this
function gives true “plug and play” capability, just need to plug-in the
network cable to the hub directly and don’t care if the end node is NIC
(Network Interface Card) or switch and hub.
These ports can operate in
half-duplex mode for 10/100Mbps and full- duplex mode for
10/100/1000Mbps.
mini-GBIC Ports:
GSW-1675T is equipped with two mini-GBIC ports, supported
optional 1000BASE-SX/LX mini-GBIC module.
Port 15 and 16 are the same ports with the mini-GBIC no.15 and 16
ports, when plug in the mini-GBIC module, the device will activate
mini-GBIC, and the RJ45 port will be disabled.
Note: When the port was set to “Forced Mode”, the Auto
MDI/MDIX will be disabled.
13