The front panel leds, 3 the front panel leds – Little Wonder ZyAIR G-4100 User Manual
Page 5
ZyAIR G-4100
5
Table 1 Side Panel Connections
LABEL DESCRIPTION
PRINTER
Use the printer cable to connect an “exclusive printer” to this port.
LAN 1-4
These ports are auto-crossover, (”auto MDI/MDI-X”) which means you can use either a
straight-through or crossover Ethernet cable to connect the ZyAIR to a computer or a hub.
WAN
Connect your broadband modem to this port with the Ethernet cable that came with your
modem.
RESET
You only need to use this button if you’ve forgotten the ZyAIR’s password. It returns the
ZyAIR to the factory defaults (password is 1234, LAN IP address 192.168.1.1).
POWER 5VDC
After you’ve made the above connections, connect the ZyAIR’s included power adaptor to
the ZyAIR’s power socket. Use only the included power adaptor. The PWR LED turns on.
The LAN and WAN LEDs flash and then turn on if they have proper connections. The
ZyAIR LED turns on for 20 seconds and then turns off. The SYS LED turns on. The ZyAIR
LED turns back on and blinks if the wireless connection is active.
1.3 The Front Panel LEDs
Figure 2 ZyAIR Front Panel