Lennox Hearth COUNTRY COLLECTION 506033-35 - Manual (Page 7)

7
Step 7. Plug the power cord into grounded 120 VAC receptacle. Do
not route the power cord under the stove or allow it to come in
contact with any surface of the stove.
Step 5. Plug the blower harness into plug on rear of snap switch bracket.
See Figure 32.
Step 3. Locate the tabs on the back of the control box. Slide the tabs
onto the upper edge of the left side heatshield. See Figures 29
and 30.
Step 4. Using a 9/16” wrench, slowly start to tighten the bottom heatshield
bolt. While tightening bolt, and before snug, make sure the snap
switch housing does not shift. DO NOT OVERTIGhTEN. Make sure
snap switch is making firm, flat contact with ashlip, and does not
shift. See Figure 31.
Step 6. Visually inspect wires are clear of contact with firebox. See
Figures 32 and 33.
Figure 29
Figure 31
Figure 32
Figure 30
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Upper Edge Of The
Left Side heatshield
Tabs
Control Box
Snap Switch
housing
Blower Wire harness
Snap Switch Bracket
Figure 33
Snap Switch
Bottom of Firebox
Snap Switch harness