LG GSA-4120B - Manual (Page 5)

2
Follow these precautions when handling the drive or discs.
• Please take notice that the manufacturer of this equipment does not offer any warranty against data
loss due to inappropriate installation or handling, or direct or indirect damages.
• Please take notice that the manufacturer will bear no responsibility for direct or indirect damages caused
by the use of this product or its malfunction.
• Please take notice that the manufacturer will bear no responsibility for damage to data caused by this
product.
• Please backup (copy) all important data as a protection against data loss.
• Avoid placing the drive in a location subject to:
- high humidity, high temperature, excessive dust, mechanical vibration, direct sunlight
We recommend using the drive in a horizontal or vertical position. Do not use it in tilted position.
• Don’t move the drive suddenly from a cold place to a warm one or raise the room temperature
suddenly. Condensation may occur, causing abnormal operation.
• Make sure to remove the disc before moving the drive. The disc may become damaged, causing data loss.
• Be careful to prevent foreign objects, such as liquids or metal, from entering the drive. In case a
foreign object enters the drive, please consult the dealer where the drive was purchased.
• Don’t interrupt the electric power while the drive is operating.
• When connecting two IDE devices to the Primary or Secondary connectors, make sure that the two
devices are not configured as both Master, or both Slave. If they are both set the same, Windows
may fail to run or recognize the drives.
• The total length of the IDE cable should be no more than 18 inches (about 45 cm).
Important Precautions
System Environment
Computer
This unit can be operated in the system environment explained here.
Pentium 4 1.6GHz or Higher with IBM PC or Compatible.
128MB or greater.
10GB or more free space.
(The free space needed for writing depends on the quantity of data.)
Enhanced-IDE interface (as Primary Slave, Secondary Master or Slave)
5.25-inch half-height bay required
+5V/+12V power socket required
Windows 98SE/2000 Professional/ME/XP(Home Edition/
Professional), Direct X 9.0 or Higher is required
CD-R : LG, Mitsubishi Chemical, Verbatim, Taiyo Yuden, TDK or SKC
discs are recommended.
CD-RW : LG, Ricoh, Mitsubishi Chemical, Verbatim discs are recommended.
DVD-R : Maxell, Taiyo Yuden, JVC are recommended.
DVD-RW : JVC, Mitsubishi Chemical, TDK are recommended.
DVD+R : Taiyo Yuden, JVC, Ricoh are recommended.
DVD+RW : TDK, FujiFilm are recommended.
DVD-RAM : Maxell, Panasonic are recommended.
DVD+R DL : Mitsubishi Chemical is recommended.
System
requirements
Hard disk
Interface
Drive bay
Power
Software Required OS
CD-R, CD-RW, DVD-R,
DVD-RW, DVD+R,
DVD+RW, DVD-RAM
discs
CPU
Memory
* Compatibility problem in write/read function may occur with some DVD+R Double Layer media
depending on the media manufacturing quality.