LG GSA-4120B - Manual (Page 7)

4
Before installing the drive, please note the following points.
■ You will need the following:
• A screw driver of a suitable size to fit the securing screws for the drive unit.
• The manual for the computer, so you can find the mounting positions for the IDE
controller cable.
■ Turn off all peripheral appliances of the computer and the computer itself, and dis-
connect their power cords from the wall sockets.
■ Discharge any static electricity on your person by touching the computer covers, etc.
Removing the Computer Cover
Make sure all peripheral devices of the computer and the computer itself are turned off,
and then remove the cover. Refer to the manual for the computer for details about
removing the cover.
NOTE : There may be sharp edges inside the computer so take care to avoid injury.
Mounting the Drive
1. Remove the 5
1
/4 ″ drive bay panel from the computer. Refer to the manual for the
computer for details.
2. Insert the drive unit into the bay. Do not apply excessive pressure to the cables inside
the computer.
3. Secure the drive with the screws provided. If there is not enough space behind the
drive, connect the IDE and other cables before securing the drive.
NOTE : This is a general installation guide.
If your PC hardware appears different,
please consult your hardware manual for
installing peripheral devices.
Jumper Setup
Before installation, set the jumper connector on the rear panel.
The drive can be connected as the Master or Slave on an EIDE (ATAPI) interface. When
several (up to four) EIDE devices are connected, each must be set in a unique way.
Specific knowledge of hardware and software is necessary to install the drive.
Installing the Drive
READ READ WRIT E
READ READ WRIT E
NOTE : If two peripheral devices with the same
settings are both connected to the Primary or to
the Secondary EIDE bus, the host computer may
fail to run or may malfunction. Careful attention is
necessary.
AUDIO OUT SELECT IDE INT ERFAC E CON NECTO R
INPUT DC
39
40
1
2 5V GND 12V
R GND L C.SEL SLAVE MASTER
MA: Master
SL: Slave
CS: Cable Select (CSEL)