Lexicon Controller Version 4 EQ MC-12 - Manual (Page 19)

Configuring the MC-12 for V4 EQ
2-5
Version 4 EQ User Guide
CONNECTING THE MICROPHONES
Automatic calibration requires the microphones included in the
Lexicon Microphone Kit, which is available at authorized Lexicon
dealers. Performing automatic calibration with other microphones
will produce unknown results.
• The microphones included in the Lexicon Microphone Kit require
careful handling. Dropping or otherwise physically abusing the
microphones may cause errors during use or irreparable damage to the
microphones. Read and observe the documentation included with the
Lexicon Microphone Kit to ensure optimal microphone performance.
• Never make or break microphone input connections unless the MC-12
is powered off using the rear panel power switch or placed in standby
mode using the front panel or remote control standby button.
To connect the microphones:
1. Make sure the MC-12 is powered off using the rear panel
power switch or placed in standby mode using the front panel
or remote control standby button.
CAUTION
2. Connect the microphones included in the Lexicon Microphone
Kit to the microphone input connectors on the MC-12 rear
panel (shown in Figure 2-1). Make sure microphone cable
plugs are fully inserted for solid connections.
Note:
During the microphone check, the MC-12 refers to
the microphones as 1, 2, 3, and 4 based on the
microphone input connector to which the microphone
is connected. Label the microphones for troubleshooting
purposes.
3. Power on the MC-12 or take the MC-12 out of standby mode.
TRIGGER OUTPUTS
MAIN AUDIO O
3
1 2 3 4
MICROPHONE INPUTS
LFE
Figure 2-1. Microphone input connectors on MC-12 rear panel.