Lopi DVL Insert EF II - Manual (Page 42)

42 Optional Equipment
(for qualified installers only)
© Travis Industries 4060111 100-01174
4 Attach the rheostat assembly and wiring harness as shown below.
Disconnect the molex connector
leading to the power cord.
Attach the two molex connectors on the
rheostat wiring harness to the power cord and
the molex connector on the appliance.
Attach the quick-
connect from the
accent light to the
quick-connect on the
rheostat wiring
harness.
Use the included wire nut to connect
the wire leading from the rheostat to
the remaining wire leading from the
accent light.
Slide the rheostat assembly into
place and secure with the
included nuts.
d
e
Make sure all wiring does not contact the
firebox or blower (use wireties if necessary).
a
b
c
NOTE: Make sure the
grounding wire remains
attached (if applicable).
5 Restore the firebox to the correct configuration (replace the burners, etc.).
Accent Light Operation
NOTE: The accent light responds
best when turned to high, then
turned down to the desired light
level.
OFF
Turn the dial all the
way counter-clockwise
until it clicks off.
HIGH
The high position
is all the way
clockwise.
LOW
Turn the dial 180°
clockwise until the light
begins to glow.