Lennox Hearth VIN - Manual (Page 5)

5
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
PRE-INSTALLATION
Panel Kits (Required)
Cat. No. Model Description
75199 VINT-CPS-B Cast Iron Panel Set/Black, Reversible
H7406 VINTAGE-PK-BG Gallo Veneziano Stone Panels
Features
Installation Options
Residential
Vented vertical and horizontal
Manufactured (mobile) home
Natural gas (NG) or propane (LP)
Bedrooms
Optional wall-mounted or remote thermostat
Venting
This stove can be vented with Security™ Secure Vent™ pipe*. Coaxial
pipe diameters are 6-5/8” outer and 4” inner. The combustion air for
this stove is drawn from outside the house through the outer DV (direct
vent) pipe. Room air is not required for combustion.
When planning your installation, select the correct length of vent pipe
for your particular requirements. Determine the minimum clearance to
combustibles from the rear of the unit to the wall. It is also important
to note the thickness of the wall. Before cutting the vent hole through
the wall make sure that ALL vent and termination clearances (see Page
15) will be met.
Electrical
The standard fan motor requires 120 Volts AC for operation. The stove is
not dependent on the fan or an outside electrical supply to operate.
WARNING - Electrical Grounding Instructions - This appliance is
equipped with a three-prong (grounding) plug for your protec-
tion against shock hazard and should be plugged directly into a
properly grounded three-prong receptacle. Do not cut or remove
the grounding prong from this plug.
Millivolt Valve
This stove is operated with a millivolt valve and therefore burns even
during a power outage.
Fuel
This stove comes from the factory equipped to burn natural gas at a specified
elevation. The stove can be converted to burn LP gas (liquid propane) by
changing the cassette (valve and pilot assembly) or installing a conversion
kit. Only Lennox Hearth Products conversion kits can be used to convert
from NG to LP or LP to NG. Contact your Lennox Hearth Products dealer
for details.
Specifications
Stove weight: 150 lbs
Pipe:Type - direct-vent
Recommended manufacturer*
Security™ Secure Vent™*
Diameter - 6-5/8”x 4” for all installations
Stove Packaging List
The Vintage™ gas stove comes with the following parts:
1 Stove Body with Burner Cassette
1 Log Set
1 Bag of Ember Material
1 Bag of the volcanic stone.
1 Installation and Operation Manual
Optional Parts
150 CFM Blower
Reversible Cast-Iron Panels
Gallo Veneziano Stone Panels
Remote Controls
Digital Wall Thermostat Kit
Note: See Pages 24 and 25 for ordering information.
* Other approved chimney brand is Simpson Dura-Vent DV-GS.
RATINGS
Vintage™ (VIN)
NATURAL GAS LP GAS
Max/Min Input BTUh 0-,000 Feet
(0-610 M) u
27,000 / 19,500 27,000 / 21,300
Manifold Pressure (IN. WC) 3.5 / 1.8 10.0 / 6.0
Min. Inlet Pressure (IN. WC) 5.0 11.0
Maximum heat output BTUs/hour-steady state ,140 ,140
P4 Efficiency w 47.00% 49.07%
Orifice (DMS) 0-,000 Feet (0-610 M) u #40/.098 IN. #53/.060 IN.
u Unit factory equipped for 0-000 FT/0-610 M, In Canada 0-4500 FT/0-1370 M
v The Steady State Efficiency numbers based on maximum vent configuration.
w Tested to CSA P.4.1-0 “Testing Method for Measuring Annual Fireplace Efficiency.
Electrical Rating: 10 VAC, 60 HZ, Less Than  Amps