Little Wonder Xtra - Manual (Page 10)

S
TARTING AND
S
TOPPING
I
NSTRUCTIONS
1. Place lawn edger on ground in horizontal
position (see Fig. 9C). Be sure the ignition
switch is “ON.” Pull switch toward
operator to turn ON. Switch is located
on right side of trigger (see Fig. 8).
2. COLD START: Move choke lever up to
start (closed) position (Fig. 9A). Press and
release primer 3 or 4 times until the fuel
flows into the clear tube (Fig. 9B). Place
one foot on the cross brace. Make sure you
have a firm footing. Hold down engine
with left hand and with right hand, pull the
starter grip slowly until you feel it engage -
and then give it a fast pull (Fig. 9C).
Do not pull out starter rope more than 26”
(65 cm) - it might break.
3. Stand between handles to start. Do not let
starter grip snap back. Guide it back slowly
so that the starter rope can rewind slowly.
4. PULL THE STARTER ROPE BRISKLY
until you hear the engine sound like it
wants to run or runs then stops (normally
1-5 pulls).
5. Open choke gradually (open position,
Fig. 9A) to allow engine to run.
10
NOTE: In warm temperatures or with hot
engine, this step may not be necessary.
6. HOT OR WARM START: (Engine has
already been started and warmed up.)
Switch ignition “ON.” Pull starter until
engine runs.
WARNING
The blade will rotate when engine is
idling fast or when engine is cold).
TO STOP ENGINE move ignition switch
forward into the “OFF” position (Fig. 8).
▲
!
▲
!
FIG 8
FIG 9C
FIG 9A FIG 9B