Little Wonder Xtra - Manual (Page 8)

A
SSEMBLING THE
X
TRA
E
DGER
F
UEL
M
IX AND
F
UELING
1. Fit cross brace (Key #68) to handles (Key #35 & 36) with brace touching the ground. Use 4
screws (Key #1) and 4 locknuts (Key #2) provided in packet.
2. Fit handle assembly to edger. Insert 150mm (6”) bolt through left handle, edger body and right
handle. Screw large wing nut (Key #85) on bolt (Key #31) so that bolt end is approximately flush
(level) with face of the center boss of the large wing nut. This allows handle “platform” to “float”
without vibration. DO NOT OVERTIGHTEN WING NUT.
3. Fit throttle (Key #50) to right handle (Key #36). Clip in throttle cable/ignition switch wire with
2 cable clamps (Key #60) attached to handle. THROTTLE CABLE FROM ENGINE MUST BE
FITTED UNDER HANDLE. DO NOT LOOP OVER HANDLE.
8
WARNING DANGER
FUEL IS EXTREMELY FLAMMABLE. HANDLE IT WITH CARE.
KEEP AWAY FROM IGNITION SOURCES.
DO NOT SMOKE WHILE FUELING YOUR EQUIPMENT.
▲
!
▲
!
FIG 6
60 50
31
85
85
1
35
2
36
68
Your Little Wonder Xtra Edger is powered by a
commercial, two-stroke, air cooled engine
which requires a fuel mixture of gasoline and
two-cycle oil.
Use a mixture of 50 parts unleaded regular
gasoline and 1 part two-cycle oil (50:1). Use
branded 89 octane unleaded gasoline or gasohol
(maximum 10% ethyl alcohol, or 15% MTBE,
no methyl alcohol.)