Lowrance electronic Satellite Weather Radio Module LWX-1 - Manual (Page 10)

8
If LED blinks ON/OFF three times during the power-up cycle and then turns OFF,
an Ethernet loop back connector should be connected to the IM Network Cable and
the LWX-1 should be power cycled. If the blinking during power-up does not recur,
then the IM Network Cable is good, and the end-user device should be checked.
When IM Network Cable is properly connected to the host device, the end-user can
request a full LWX-1 Diagnostics Report to perform any further required diagnosis.
The following section describes the information provided in this diagnostic report.
The SIRIUS satellite service activation process will require the SIRIUS ID for the
SIRIUS Radio Module is visible to the user. This will allow the SIRIUS Listener
Care call center to activate the user’s subscription for the LWX-1. Signal Strength
will also be important information for the user to verify that SIRIUS radio signal is
available as this is required for successful activation.
LWX-1 SIRIUS Activation
You must have a SIRIUS subscription to use the LWX-1 module. Individual weather
and audio subscriptions are available. You can also purchase a subscription that
includes both weather and audio.
Before calling SIRIUS to activate a subscription for your LWX-1 make sure the
following conditions are met:
The LWX-1 and your display unit are turned on and connnected via •
ethernet cable
SIRIUS status info — antenna status and signal strength — is shown
•
on your display unit screen (refer to your unit’s operation manual to
access the SIRIUS status screen)
SIRIUS status screen shows signal strength of at least 1/3 with 2/3 or
•
greater preferred
Have the ESN — electronic serial number — for the LWX-1 readily
•
available (ESN, a 12-digit number, can be found on the LWX-1 carton,
LWX-1 antenna or via the SIRIUS status screen)
Credit card/billing information is available
•