Lowrance electronic Satellite Weather Radio Module LWX-1 - Manual (Page 5)

3
1. AR Mast Mount Installation
The LWX-1 AR is shipped in the retail box factory-configured for a mast mount.
To use AR Mast Mount Installation:
Loosen the four AR Bolts & Nuts (a couple of counter-clockwise 1.
turns on each).
The AR Mast Boot will loosen, allowing the AR Mast Mount to turn.
2.
Insert the AR Interconnect Cable into the Antenna Mount and route 3.
it carefully to the Interface Module (IM). Planning the cable route in
advance will avoid multiple cable pulls that could increase the likeli-
hood of damaging the connector.
Align the AR in the general position desired and screw the AR Mast
4.
Mount onto the Antenna Mount (hand-tighten as much as possible
– DO NOT OVER-TIGHTEN). Note that the AR is a friction fit de-
signed to allow for the occasional hand alignment.
With the AR Mast Mount installed, align the AR in position desired
5.
and re-tighten the four AR Bolt & Nuts.
Insert AR Screw Caps into AR Bolt recesses on the AR Cover.
6.