4 keeping your shaver in top shape – Braun 7526 User Manual

Page 5

Advertising
background image

5

combi shave

= Combination shave (InterFace trimmer works in tandem

with the shaver foil to first cut the longer problem hairs,
which then allows the foil to shave the shorter hairs even
closer) (b).

trimmer

= The long hair trimmer is activated (for trimming sideburns,

moustache and beard) (c).

3.2 Shaving with the cord

If the batteries are discharged, you may also shave with the shaver connected
to the mains (100–240 V ~). (If the shaver should not run immediately, charge
it with the switch position «off» for approx. 1 minute.)

4 Keeping your shaver in top shape

4.1 Cleaning

After shaving, switch the shaver off. Press the release buttons, take off the
shaver foil (d) and gently tap it out on a flat surface (e).

Then thoroughly clean the cutter block with the brush (f). About every four
weeks, clean the cutter block with Braun cleaning agents (g).

Do not clean the shaver foil with the brush.

If you have a very dry skin and you notice a reduced operation time of the
shaver, you should put a drop of light machine oil onto the InterFace trimmer
and shaver foil (g).

4.2 Replacing the shaving parts

The shaver foil and cutter block are precision parts that, in time, are subject
to wear. A regular replacement of the parts every 1

1

/

2

years or when these

parts are worn, will ensure, that you are getting the close, comfortable and
quick shave you expect from your Braun shaver.
(Shaver foil and cutter block: part no. 3000)

Press the release buttons, take off the shaver foil. Replace the new shaver foil
in the right direction until it locks in place.

To remove the cutter block, lift it off (g).

To replace the cutter block, snap onto the holding studs.

Tips for the perfect shave

• We recommend that you shave before washing, as the skin tends to be

slightly swollen after washing.

• Hold the shaver at right angles (90°) to the skin.
• Stretch your skin and shave against the direction of beard growth.
• Replace the shaver foil and cutter block every 1

1

/

2

years, or when the parts

are worn, to ensure optimum shaving performance.

5635482_IF3775/70_S4_54 Seite 5 Mittwoch, 9. April 2003 2:05 14

Advertising