Lincoln Electric 11395 - Manual (Page 26)

D-3 MAINTENANCE D-3
ENGINE ADJUSTMENTS
OVERSPEED IS HAZARDOUS
The maximum allowable high idle speed for this
machine is 3750 RPM, no load. Do NOT tamper
with governor components or setting or make any
other adjustments to increase the maximum
speed. Severe personal injury and damage to the
machine can result if operated at speeds above
maximum.
------------------------------------------------------------------------
Adjustments to the engine are to be made only by a
Lincoln Service Center or an authorized Field Service
Shop.
SLIP RINGS
A slight amount of darkening and wear of the slip rings
and brushes is normal. Brushes should be inspected
when a general overhaul is necessary.If brushes are
to be replaced, clean slip rings with a fine emery
paper.
Do not attempt to polish slip rings while engine is
running.
------------------------------------------------------------------------
BATTERY
1. When replacing, jumping, or otherwise connecting
the battery to the battery cables, the proper
polarity must be observed. Failure to observe
the proper polarity could result in damage to the
charging circuit. The positive (+) battery cable
has a red terminal cover.
2. If the battery requires charging from an external
charger, disconnect the negative battery cable
first and then the positive battery cable before
attaching the charger leads. Failure to do so
can result in damage to the internal charger
components. When reconnecting the cables,
connect the positive cable first and the negative
cable last.
HARDWARE
Both English and Metric fasteners are used in this
welder.
RANGER 10,000 PLUS AND RANGER 10,000
WARNING
GASES FROM BATTERY can explode.
• Keep sparks, flame and cigarettes away from battery.
To prevent EXPLOSION when:
• INSTALLING A NEW BATTERY - disconnect negative
cable from old battery first and connect to new battery
last.
• CONNECTING A BATTERY CHARGER - Remove bat-
tery from welder by disconnecting negative cable first,
then positive cable and battery clamp. When rein-
stalling, connect negative cable last. Keep well venti-
lated.
• USING A BOOSTER - connect positive lead to battery
first then connect negative lead to engine foot.
BATTERY ACID CAN BURN EYES AND SKIN.
• Wear gloves and eye protection and be careful when
working near battery. Follow instructions printed on
battery.
WARNING
CAUTION
KOHLER C23S SUBARU ROBIN EH65
KOHLER 1205001 SUBARU ROBIN
Oil Filter FRAM PH8172* 248-65801-00, FRAM PH4967
Air Filter KOHLER 4708303 SUBARU ROBIN
Element FRAM CA79 263-32610-A1
Air Filter KOHLER 2408302 N/A
Pre-Cleaner
Fuel Filter KOHLER 2405010 SUBARU ROBIN
011-00600-20
Spark Plugs CHAMPION RC12YC SUBARU ROBIN
(Resistor (.030 ” GAP) X65-01407-30
Type) NGK-BPR4EY
HONDA GX620KI
HONDA
15410-ZJ4-999A
HONDA
17210-ZJ1-841
HONDA
17218-ZJ1-840
HONDA
16910-ZE8-015
CHAMPION -J16CR-U
NGK-ZGR5A
030in, (76 mm) Gap
* Oil capacity increases from 2.0 Qts. to 2.1 Qts. when using this filter.
ENGINE MAINTENANCE PARTS